test-scripts/backchannel

#!/bin/sh

#
# Copyright (C) 2012 The Android Open Source Project
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
#      http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#

# Backchannel control script - sets up and tears down backchannel network
# interfaces. Backchannel interfaces are hidden from flimflam and will never be
# the default route.
#
# A backchannel interface can also be used to simulate a cellular
# modem used by fake-cromo if the new interface name is set to
# pseudo-modem0
#

test_if=eth_test

usage () {
  echo "Usage: $0 <command> [args...]"
  echo "  setup <iface> [new_iface_name]    Set <iface> as backchannel device"
  echo "  teardown <iface> [new_iface_name] Return backchannel device to normal"
  echo "  reach <ip> <gw> [new_iface_name]  Route <ip> via gateway <gw>"
}

macaddr() {
  ip addr show "$1" | awk '/link\/ether/ { print $2 }'
}

ipaddr_with_subnet_mask() {
  ip addr show "$1" | awk '/inet / { print $2 }'
}

# We need to down the interface (and therefore stop flimflam) across the
# invocation of nameif, according to nameif(1).
renameif() {
  old="$1" ; shift
  new="$1" ; shift
  initctl stop shill
  ip link set "$old" down
  nameif "$new" $(macaddr "$old")
  ip link set "$new" up
  initctl start shill
}

setup() {
  oldip=$(ipaddr_with_subnet_mask "$1")
  if [ ! -z $2 ] ; then
    test_if="$2"
  fi
  renameif "$1" "$test_if"
  ip addr add "$oldip" dev "$test_if"
}

teardown() {
  if [ ! -z $2 ] ; then
    test_if="$2"
  fi
  renameif "$test_if" "$1"
}

reach() {
  ip="$1" ; shift
  gw="$1" ; shift
  if [ ! -z $1 ] ; then
    test_if="$1"
  fi
  ip route add "$ip" via "$gw" dev "$test_if"
}

if [ -z "$1" ]; then
  usage
  exit 1
fi

command="$1" ; shift
case "$command" in
  setup)
    setup "$@"
    ;;
  teardown)
    teardown "$@"
    ;;
  reach)
    reach "$@"
    ;;
  *)
    usage
    ;;
esac