win/idl/nsIInputStreamTee.idl

/* -*- Mode: C++; tab-width: 4; indent-tabs-mode: nil; c-basic-offset: 4 -*- */
/* ***** BEGIN LICENSE BLOCK *****
 * Version: MPL 1.1/GPL 2.0/LGPL 2.1
 *
 * The contents of this file are subject to the Mozilla Public License Version
 * 1.1 (the "License"); you may not use this file except in compliance with
 * the License. You may obtain a copy of the License at
 * http://www.mozilla.org/MPL/
 *
 * Software distributed under the License is distributed on an "AS IS" basis,
 * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
 * for the specific language governing rights and limitations under the
 * License.
 *
 * The Original Code is mozilla.org code.
 *
 * The Initial Developer of the Original Code is
 * Netscape Communications Corporation.
 * Portions created by the Initial Developer are Copyright (C) 2001
 * the Initial Developer. All Rights Reserved.
 *
 * Contributor(s):
 *   Darin Fisher <darin@netscape.com> (original author)
 *
 * Alternatively, the contents of this file may be used under the terms of
 * either of the GNU General Public License Version 2 or later (the "GPL"),
 * or the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
 * in which case the provisions of the GPL or the LGPL are applicable instead
 * of those above. If you wish to allow use of your version of this file only
 * under the terms of either the GPL or the LGPL, and not to allow others to
 * use your version of this file under the terms of the MPL, indicate your
 * decision by deleting the provisions above and replace them with the notice
 * and other provisions required by the GPL or the LGPL. If you do not delete
 * the provisions above, a recipient may use your version of this file under
 * the terms of any one of the MPL, the GPL or the LGPL.
 *
 * ***** END LICENSE BLOCK ***** */

#include "nsIInputStream.idl"

interface nsIOutputStream;

/**
 * A nsIInputStreamTee is a wrapper for an input stream, that when read
 * reads the specified amount of data from its |source| and copies that
 * data to its |sink|.  |sink| must be a blocking output stream.
 */
[scriptable, uuid(44e8b2c8-1ecb-4a63-8b23-3e3500c34f32)]
interface nsIInputStreamTee : nsIInputStream
{
    attribute nsIInputStream source;
    attribute nsIOutputStream sink;
};

%{C++
// factory method
extern NS_COM nsresult
NS_NewInputStreamTee(nsIInputStream **tee, // read from this input stream
                     nsIInputStream *source,
                     nsIOutputStream *sink);
%}