chromeos-base/infineon-firmware-updater/files/send-tpm-firmware-update-metrics.conf

# Copyright 2017 The Chromium OS Authors. All rights reserved.
# Use of this source code is governed by a BSD-style license that can be
# found in the LICENSE file.

description   "Report UMA statistics for completed TPM firmware updates"
author        "chromium-os-dev@chromium.org"

start on started system-services

script
  # Report updater status for this boot. The updater's status code
  # gets written to the tpm-firmware-updater.status file by the
  # tpm-firmware-update init job that runs during early boot.
  status="$(cat /run/tpm-firmware-updater.status || :)"
  if [ -n "${status}" ]; then
    metrics_client -s Platform.TPM.FirmwareUpdate.Status "$((status))"
  fi
  rm -f /run/tpm-firmware-updater.status

  # Read firmware update parameters directly from VPD instead of
  # looking at the cache. This is necessary in case they were modified
  # during recovery, which may leave the cache out of sync.
  vpd_params="$(vpd -i RW_VPD -g tpm_firmware_update_params | tr ',' '\n')"

  # Decode key-value pairs.
  while IFS=":" read -r key value; do
    sanitized_key="$(
      echo "${key}" | tr '[:upper:] ' '[:lower:]_' | tr -cd '[:alnum:]_-')"
    sanitized_value="$(echo "${value}" | tr -cd '[:alnum:]._-')"
    readonly "vpd_param_${sanitized_key}=${sanitized_value}"
  done <<EOF
${vpd_params}
EOF

  # Don't report any metrics if dryrun is on.
  if [ "${vpd_param_dryrun}" = "1" ]; then
    exit
  fi

  # Report appropriate metrics for terminal states.
  case "${vpd_param_mode}" in
    complete)
      # Successful update. Look at the number of attempts to see
      # whether it went smoothly or not. More than one attempt
      # indicates a successful retry in recovery mode.
      if [ "${vpd_param_attempts}" = "1" ]; then
        metrics_client -e Platform.TPM.FirmwareUpdate.Result 0 3
      else
        metrics_client -e Platform.TPM.FirmwareUpdate.Result 1 3
      fi
      metrics_client -e Platform.TPM.FirmwareUpdate.Attempts \
        "${vpd_param_attempts}" 10
      ;;
    failed)
      # Failed updater run that however didn't cause subsequent boot
      # failure (otherwise being here indicates we've gone through
      # successful retry in recovery mode, which should have flipped
      # mode to "complete".
      metrics_client -e Platform.TPM.FirmwareUpdate.Result 2 3
      ;;
    *)
      # Bail out to avoid deleting the VPD key in non-terminal states.
      exit
      ;;
  esac

  # Clear the VPD so we don't report again.
  vpd -i RW_VPD -d tpm_firmware_update_params
end script