Servo AVR keyboard emulator
---------------------------

This firmware installs into the avr in Servo v2, v3, v4 to allow serial control
of a USB keyboard. It is intended to take the place of usb-km232
http://www.hagstromelectronics.com/products/usbkm232.html and retain
compatibility with the hdctools/usbkm232 library.

Software is built on:
http://www.fourwalledcubicle.com/LUFA.php LUFA release 140928


To use:
enable via --usbkm232=atmega commandline option.


Manual config: (this is taken care of via --usbkm232=atmega)
Confirm the serial port is 9600/8/n/1:
dut-control atmega_baudrate:9600 atmega_bits:eight atmega_parity:none atmega_sbits:one

Confirm the serial port location:
dut-control atmega_pty
atmega_pty:/dev/pts/31

Confirm the AVR is connected to USB via the USB mux.
dut-control atmega_rst:off
dut-control usb_mux_sel4:on

Verify on the DUT that the avr is visible:
lsusb should show "LUFA Keyboard"

cd ~/trunk/src/third_party/hdctools/usbkm232
USBKM232_UART_DEVICE=/dev/pts/31 python ./space.py


To build:
Install the AVR toolchain (outside chroot):
sudo apt-get install gcc-avr binutils-avr gdb-avr avr-libc avrdude

Unzip LUFA, downloaded from
http://www.github.com/abcminiuser/lufa/archive/LUFA-140928.zip
and copy LUFA to this directory.

cd KeyboardSerial
make

Keyboard.hex is generated.


To install:
Plug both HOST_IN and DUT_HUB_IN usb ports to the host, and start servod.

Boot AVR into DFU mode by enabling the HardWareBoot mode strapping and reset:
dut-control at_hwb:on
dut-control atmega_rst:on
dut-control atmega_rst:off
dut-control at_hwb:off

Select avr on the USB mux.
dut-control usb_mux_sel4:on

At this point you will see an Atmel DFU device in lsusb.

Flash:
sudo dfu-programmer atmega32u4 erase
sudo dfu-programmer atmega32u4 flash main.hex

Reboot:
dut-control at_hwb:off
dut-control atmega_rst:on
dut-control atmega_rst:off

At this point you should see a "LUFA Keyboard" in lsusb.