servo/data/servo_lucidcosmos_overlay.xml

<?xml version="1.0"?>
<root>
  <include>
    <name>servoflex_cosmos.xml</name>
  </include>
  <control>
    <name>kbd_en</name>
    <doc>Keyboard gpio's needed for ec_boot_mode</doc>
    <params clobber_ok="" init="on"></params>
  </control>
  <control>
    <name>kbd_m2_a1</name>
    <params clobber_ok="" init="off"></params>
  </control>
  <control>
    <name>kbd_m2_a0</name>
    <alias>ec_boot_mode</alias>
    <doc>EC boot mode GPIO</doc>
    <params clobber_ok="" map="onoff_i" init="off"></params>
  </control>
  <!-- lucid uses cpu uart as ec.  Below will map ec_* names to cpu uart as
       well. -->
  <control>
    <name>ec3po_ec_console</name>
    <alias>cpu_uart_pty</alias>
    <params clobber_ok="" interface="10"></params>
  </control>
  <control>
    <name>uart2_en</name>
    <alias>ec_uart_en</alias>
    <params clobber_ok="" interface="2" drv="tca6416" slv="0x24"
    port="0" offset="6" map="onoff_i" init="on"></params>
  </control>
  <control>
    <name>uart2_pty</name>
    <alias>raw_ec_uart_pty</alias>
    <params clobber_ok="" interface="8"></params>
  </control>
  <control>
    <name>uart2_baudrate</name>
    <alias>ec_uart_baudrate</alias>
    <params clobber_ok="" interface="8"></params>
  </control>
  <control>
    <name>uart2_parity</name>
    <alias>ec_uart_parity</alias>
    <params clobber_ok="" interface="8"></params>
  </control>
  <control>
    <name>uart2_sbits</name>
    <alias>ec_uart_sbits</alias>
    <params clobber_ok="" interface="8"></params>
  </control>
  <control>
    <name>uart2_bits</name>
    <alias>ec_uart_bits</alias>
    <params clobber_ok="" interface="8"></params>
  </control>
</root>