| #### 15.4 Calculation of Control Parameters {#h-15-04} | |
| We conclude the discussion of loop filtering by showing how the thresholds supplied to the procedures above are derived from the two control parameters `sharpness_level` (an unsigned 3-bit number having maximum value 7) and `loop_filter_level` (an unsigned 6-bit number having maximum value 63). | |
| While the `sharpness_level` is constant over the frame, individual macroblocks may override the `loop_filter_level` with one of four possibilities supplied in the frame header (as described in Chapter 10). | |
| Both the simple and normal filters disable filtering if a value derived from the four pixels that straddle the edge (2 either side) exceeds a threshold / limit value. | |
| ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ | |
| /* Luma and Chroma use the same inter-macroblock edge limit */ | |
| uint8 mbedge_limit = ((loop_filter_level + 2) * 2) + | |
| interior_limit; | |
| /* Luma and Chroma use the same inter-subblock edge limit */ | |
| uint8 sub_bedge_limit = (loop_filter_level * 2) + interior_limit; | |
| ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ | |
| {:lang="c"} | |
| The remaining thresholds are used only by the normal filters. The filter-disabling interior difference limit is the same for all edges (luma, chroma, inter-subblock, inter-macroblock) and is given by the following. | |
| ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ | |
| uint8 interior_limit = loop_filter_level; | |
| if( sharpness_level) | |
| { | |
| interior_limit >>= sharpness_level > 4 ? 2 : 1; | |
| if( interior_limit > 9 - sharpness_level) | |
| interior_limit = 9 - sharpness_level; | |
| } | |
| if( !interior_limit) | |
| interior_limit = 1; | |
| ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ | |
| {:lang="c"} | |
| Finally, we give the derivation of the high edge-variance threshold, which is also the same for all edge types. | |
| ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ | |
| uint8 hev_threshold = 0; | |
| if( we_are_decoding_akey_frame) /* current frame is a key frame */ | |
| { | |
| if( loop_filter_level >= 40) | |
| hev_threshold = 2; | |
| else if( loop_filter_level >= 15) | |
| hev_threshold = 1; | |
| } | |
| else /* current frame is an interframe */ | |
| { | |
| if( loop_filter_level >= 40) | |
| hev_threshold = 3; | |
| else if( loop_filter_level >= 20) | |
| hev_threshold = 2; | |
| else if( loop_filter_level >= 15) | |
| hev_threshold = 1; | |
| } | |
| ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ | |
| {:lang="c"} | |