| #!/bin/sh |
| |
| # |
| # Copyright (C) 2012 The Android Open Source Project |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| |
| # Backchannel control script - sets up and tears down backchannel network |
| # interfaces. Backchannel interfaces are hidden from flimflam and will never be |
| # the default route. |
| # |
| # A backchannel interface can also be used to simulate a cellular |
| # modem used by fake-cromo if the new interface name is set to |
| # pseudo-modem0 |
| # |
| |
| test_if=eth_test |
| |
| usage () { |
| echo "Usage: $0 <command> [args...]" |
| echo " setup <iface> [new_iface_name] Set <iface> as backchannel device" |
| echo " teardown <iface> [new_iface_name] Return backchannel device to normal" |
| echo " reach <ip> <gw> [new_iface_name] Route <ip> via gateway <gw>" |
| } |
| |
| macaddr() { |
| ip addr show "$1" | awk '/link\/ether/ { print $2 }' |
| } |
| |
| ipaddr_with_subnet_mask() { |
| ip addr show "$1" | awk '/inet / { print $2 }' |
| } |
| |
| # We need to down the interface (and therefore stop flimflam) across the |
| # invocation of nameif, according to nameif(1). |
| renameif() { |
| old="$1" ; shift |
| new="$1" ; shift |
| initctl stop shill |
| ip link set "$old" down |
| nameif "$new" $(macaddr "$old") |
| ip link set "$new" up |
| initctl start shill |
| } |
| |
| setup() { |
| oldip=$(ipaddr_with_subnet_mask "$1") |
| if [ ! -z $2 ] ; then |
| test_if="$2" |
| fi |
| renameif "$1" "$test_if" |
| ip addr add "$oldip" dev "$test_if" |
| } |
| |
| teardown() { |
| if [ ! -z $2 ] ; then |
| test_if="$2" |
| fi |
| renameif "$test_if" "$1" |
| } |
| |
| reach() { |
| ip="$1" ; shift |
| gw="$1" ; shift |
| if [ ! -z $1 ] ; then |
| test_if="$1" |
| fi |
| ip route add "$ip" via "$gw" dev "$test_if" |
| } |
| |
| if [ -z "$1" ]; then |
| usage |
| exit 1 |
| fi |
| |
| command="$1" ; shift |
| case "$command" in |
| setup) |
| setup "$@" |
| ;; |
| teardown) |
| teardown "$@" |
| ;; |
| reach) |
| reach "$@" |
| ;; |
| *) |
| usage |
| ;; |
| esac |