| package configs |
| |
| // Network defines configuration for a container's networking stack |
| // |
| // The network configuration can be omitted from a container causing the |
| // container to be setup with the host's networking stack |
| type Network struct { |
| // Type sets the networks type, commonly veth and loopback |
| Type string `json:"type"` |
| |
| // Name of the network interface |
| Name string `json:"name"` |
| |
| // The bridge to use. |
| Bridge string `json:"bridge"` |
| |
| // MacAddress contains the MAC address to set on the network interface |
| MacAddress string `json:"mac_address"` |
| |
| // Address contains the IPv4 and mask to set on the network interface |
| Address string `json:"address"` |
| |
| // Gateway sets the gateway address that is used as the default for the interface |
| Gateway string `json:"gateway"` |
| |
| // IPv6Address contains the IPv6 and mask to set on the network interface |
| IPv6Address string `json:"ipv6_address"` |
| |
| // IPv6Gateway sets the ipv6 gateway address that is used as the default for the interface |
| IPv6Gateway string `json:"ipv6_gateway"` |
| |
| // Mtu sets the mtu value for the interface and will be mirrored on both the host and |
| // container's interfaces if a pair is created, specifically in the case of type veth |
| // Note: This does not apply to loopback interfaces. |
| Mtu int `json:"mtu"` |
| |
| // TxQueueLen sets the tx_queuelen value for the interface and will be mirrored on both the host and |
| // container's interfaces if a pair is created, specifically in the case of type veth |
| // Note: This does not apply to loopback interfaces. |
| TxQueueLen int `json:"txqueuelen"` |
| |
| // HostInterfaceName is a unique name of a veth pair that resides on in the host interface of the |
| // container. |
| HostInterfaceName string `json:"host_interface_name"` |
| |
| // HairpinMode specifies if hairpin NAT should be enabled on the virtual interface |
| // bridge port in the case of type veth |
| // Note: This is unsupported on some systems. |
| // Note: This does not apply to loopback interfaces. |
| HairpinMode bool `json:"hairpin_mode"` |
| } |
| |
| // Routes can be specified to create entries in the route table as the container is started |
| // |
| // All of destination, source, and gateway should be either IPv4 or IPv6. |
| // One of the three options must be present, and omitted entries will use their |
| // IP family default for the route table. For IPv4 for example, setting the |
| // gateway to 1.2.3.4 and the interface to eth0 will set up a standard |
| // destination of 0.0.0.0(or *) when viewed in the route table. |
| type Route struct { |
| // Sets the destination and mask, should be a CIDR. Accepts IPv4 and IPv6 |
| Destination string `json:"destination"` |
| |
| // Sets the source and mask, should be a CIDR. Accepts IPv4 and IPv6 |
| Source string `json:"source"` |
| |
| // Sets the gateway. Accepts IPv4 and IPv6 |
| Gateway string `json:"gateway"` |
| |
| // The device to set this route up for, for example: eth0 |
| InterfaceName string `json:"interface_name"` |
| } |